Epoxy Floor Coating

UPS 882 EFC Epoxy Floor Coating

UPS 882 EFC EPOXY FLOOR COATING is a two-pack solvent free epoxy floor coating system which provides outstand protection and decorative properties to concrete and other substrates.

The material supplied as a two-pack system comprising pre-weighed amounts of Base and Activator components. After mixing together a hard-wearing gloss finish epoxy coating is produced.

It provides excellent chemical and abrasion resistant properties. It can also be used as a slip resistant flooring system when a suitable aggregate is incorporated.

UPS 882 EFC is available in RAL Colour Code – Safety yellow for line marking, to light grey for warehouse floors.

Finally its solvent free technology means its low odour is ideally suited to be used in places such as hospitals and schools.


The latest solvent free epoxy technology

Apply by brush or roller

Reduced downtime due to its fast curing properties

Excellent application characteristics

Hard wearing floor coating with a gloss finish

Outstanding chemical and abrasion resistance

Suitable for pedestrian and vehicular traffic

Formally known as HB 850


Applications for 882 EFC EPOXY FLOOR COATING include:

Factory, warehouse and laboratory floors

Brewery and food preparation floors

Walkways, anti-slip systems

Ideal for resurfacing ramps

MHSP - Home icon

Surface Preparation Manual | Mechanical | Abrasive Blast

MHSP - Home icon

Brush or Roller Applied

MHSP - money icon

Useable Life 45 minutes

MHSP - location  icon

Solvent Free


Useable Life
45 mins @ 20°C (68°F)

Abrasion Resistance
Taber CS17 Wheels / 1KG Load
20mg loss / 1000 cycles
0.22 loss / 1000 cycles

Impact Resistance
(ASTM G14)
3.95 Joules

Corrosion Resistance
(ASTM B117)
Minimum 5000 hours

Hardness Shore D
(ASTM D2240)

Available Colours
Light Grey | Dark Grey | Black | Red | Blue | Green |
Yellow | Any RAL Colour

Minimum Overcoating Window
12 hours @ 20°C (68°F)

Adhesion Tensile Shear
(ASTM D1002 on abrasive blasted mild steel
with 75 microns profile)
160KG/cm² (2,275 psi)

Compressive Strength
(ASTM D695)
649KG/cm² (9,200 psi)

Flexural Strength
(ASTM D790)
522KG/cm² (7,400 psi)

Maximum Overcoating Window
36 hours @ 20°C (68°F)

Pack Sizes
5KG | 25KG


25KG / 18LTR (5. US Gallon) of fully mixed product will give the following coverage rates

72m² at 250 microns 772ft² at 10mil

Please note that the coverage rates quoted are theoretical and don't take into consideration the profile or condition of the surface being repaired


Suitable for use in immersed conditions at temperatures up to 60°C (140°F)

Resistant to dry heat in excess of 180°C (356°F) dependent on load


The product demonstrates resistance to a wide variety of inorganic acids, alkalis’, salts and organic media

Refer to the Unique Polymer Systems Technical Centre for advice

Email: or call +44 (0) 1531 636 300

Factory floor protected with UPS 882 EFC
Bespoke garage floor using UPS 882 EFC and PVA Flake System


If you are interested in this product or need technical assistance choosing the correct product for your application –
Please contact Unique Polymer Systems


Contact us using WhatsApp