UPS 783 PSP POURABLE SILICONE POLYMER is a two component rapidly solidifying pourable silicone polymer.
The product has been specially developed for injection or for pouring into pipe collars to seal leaking surfaces.
Solvent free silicon technology
High temperature resistance
250°C
High bond strength -
Pour by hand or inject using airless pumping systems
Fast curing
Maximum coating thickness
150mm (6”)
Applications for UPS 782 PSP POURABLE SILICONE POLYMER include:
Sealing leaking low pressure steam
Sealing leaking vapour or gas lines
Surface Preparation Mechanical |
Abrasive Blast
Brush / Roller / Injection Applied
High Temperature Resistance
Solvent Free
Chemistry
Useable Life
30 minutes @ 20°C (68°F)
Initial Set
3-4 hours @ 20°C (68°F)
Available Colours
Light Grey
Full Cure
12 hours @ 20°C (68°F)
Pack Sizes
4LTR
4 LTR (1.25 US Gallon) of fully mixed material will give the following coverage rates -
1m² at 4mm 10.7ft² at 1/6”
Please note that the coverage rates quoted are theoretical and do not take into consideration the profile or condition of the surface being repaired
Resistant to dry heat up to 100°C (212°F) dependent on load
The product demonstrates resistance to a wide variety of inorganic acids, alkalis’, salts and organic media
Refer to the Unique Polymer Systems Technical Centre for advice
Email: sales@uniquepolymersystems.com or call +44 (0) 1531 636 300