UPS 909 PP POROUS PRIMER is a low viscosity solvent free epoxy primer, for use sealing and consolidating concrete and cementitious surfaces.
Solvent free epoxy technology
No shrinkage
Applied in 1 or 2 coats at 100-125 microns per coat
Cures at temperatures down to 5°C
Apply by brush, roller or standard airless spray
Formally known as SP 810
Applications for UPS 909 PP POROUS PRIMER include:
Priming porous surfaces such as concrete
Floors, tank linings, bunds, secondary containment areas
Surface Preparation Manual | Mechanical | Abrasive Blast
Brush or Roller Applied
Cures at Temperatures Down to 5°C
Airless Spray Applied
Useable Life
25 minutes @ 20°C (68°F)
Minimum Over-Coating Window
3 hours @ 20°C (68°F)
Compressive Strength
(ASTM D695)
629KG/cm²
(8945 psi)
Tensile Shear Adhesion
(ASTM D1002)
(Abrasive Blasted Mild Steel with 75 micron profile)
Mild Steel
195KG/cm²
(2770 psi)
Rusted Steel
195KG/cm²
(2770 psi)
Available Colours
Amber
Maximum Over-Coating Window
36 hours @ 20°C (68°F)
Shore D Hardness
(ASTM D2240)
84
Flexural Strength
(ASTM D790)
371KG/cm²
(5275 psi)
Pull off Adhesion
Dry
37KG/cm²
(525 psi)
Wet
33.4KG/cm²
(475 psi)
Pack Sizes
1LTR | 4LTR | 18LTR
4 LTR (1.1 US Gallon) of fully mixed material will give the following coverage rates -
26.6m² at 150 microns
286ft² at 6mil
18 LTR (4.75 US Gallon) of fully mixed material will give the following coverage rates -
119m² at 250 microns
1280ft² at 10mil
Please note that the coverage rates quoted are theoretical and don't take into consideration the profile or condition of the surface being repaired
Suitable for use in immersed conditions at temperature up to 60°C (140°F)
Resistant to dry heat up to 150°C (302°F) dependent on load