Monarch Corrosion Control Coatings

Monarch Products

Monarch manufactures a wide range of corrosion control systems for the protection of steel and concrete surfaces from corrosion and chemical attack.

Our aim is to produce high quality corrosion control products at economic prices backed by good technical advise and prompt efficient, service.

The heavy duty lining versions will in most cases out perform conventional linings, often at lower cost.

The heavy duty lining versions will in most cases out perform conventional linings, often at lower cost.Picture of a large industrial container

The Monarch Philosophy

To this end we are always trying to improve our products both by laboratory research and site experience.

Above all we listen to our clients needs and try to develop technically innovative materials to meet their requirements.

Designed for the Job

All Monarch corrosion control systems are specifically designed for their purpose.

Whether protecting steel or concrete against immersion conditions as a lining, or as a coating subject to splash and spillage and environmental conditions, or flooring with combined mechanical and chemical conditions, each system has the right combination of physical and chemical resistant properties to do its job.

Picture of two large industrial chimney stacks

Advantages

Non-undercutting
Permeation resistant
High temperature limits
Resistant to thermal shock
Abrasion resistant
Erosion resistant
Impact resistant
Repairable
Cold curing
Rapid curing
Fill pits and voids
Machinable
Flexible

Commercial

Competitive prime cost
Lower steel costs
Less down time
Refurbishes old plant
Long life
Low cost per sqm/year
Reduced maintenance costs

General

Replaces rubber, lead and stainless steel linings
Suitable for use with food products (some grades)
Fast installation
Site or works installation
Suitable for use in radiation areas
Can replace bricks and tiles

- Tel: +44 (0) 1531 63 17 27 - Fax: + 44 (0) 870 055 88 01